If you want to ensure that your asphalt driveway stays in good shape for years to come, then you need to ensure that it undergoes regular maintenance. This is true whether it is a driveway or a retail parking lot. Sealcoating is within the scope of regular maintenance. Sealing your asphalt driveway will help to minimize the formation of cracks and potholes and reduce the chances of water infiltration, not to mention it helps the driveway's overall appearance. All in all, it protects the asphalt surface from weather elements and harm. If you are interested in applying a sealer to your asphalt driveway, here are a few tips to keep in mind:
Tip #1: Make Sure You Use Protective Gear
When sealing your asphalt driveway, it is important to wear protective gear. The reason for this is that asphalt driveway sealers are considered chemicals. For that reason, the sealant should not come in contact with the skin and it should be inhaled as minimally as possible due to it being a health hazard. Therefore, make sure your skin is fully covered and that you are wearing a protective mask over your nose and mouth that will not allow you to breathe in the scent of the sealer.
Tip #2: Remove Dirt and Stains from the Surface
You need to use a garden hose or a pressure washer to remove any dirt and stains that have accumulated over time. If necessary, you can use a special detergent for the stains (especially those from gas and oil), which can be purchased at an auto supply store.
Tip #3: Fill Cracks and Finish Cleaning the Surface
Any cracks in the surface need to be filled with a patching compound that can be purchased at a home improvement store. Also, it is crucial that the surface is cleaned thoroughly. Use a garden hose or a pressure washer to thoroughly clean the surface in its entirety to ensure all remnants of dirt, debris, etc. has been removed from the surface.
Tip #4: Apply the Sealant One Section at a Time
One of the most effective ways to apply the sealant to your asphalt driveway is to start in one corner of the driveway and to work in small sections. Some think that you should work one long strip at a time, but many find that it is easier to work in smaller sections so that the sealant stays pliable and manageable. Make sure to also apply the sealant thinly on the surface and that you use a long-handed brush.
Once the sealant has been applied, it needs to dry. The amount of time may vary based on the sealant, so make sure to read the instructions and do not park your vehicle on the driveway during this time. It may be a good idea to put caution tape up so that no one will try to walk or park on the driveway. Contact a business such as Southwest Slurry Seal, Inc. for more information.